Installation Manual

3
installation of slimline ii tray
Note: If you have not fitted the Universal Load Bed Legs,
fit them according to the Universal Load Bed Leg Fitting
Instruction - Document LASS026.
If your Slimline II Tray is not already assembled,
assemble it as per the Slimline II Tray Universal Assembl
y
Instruction - Document RRSTUNI.
()
A
With your Rack in the upside down position ( Product Sticker should be upside down ) slide two M8 x 25
Hex Bolts supplied with the Universal Load Bed Legs into the end of each Slat as indicated by the arrows
using the machined Slots as shown.
You will need:
 13 mm Flat or Socket Wrench
 Measuring tape
 Friend
TRBU003 / KRLBUNI3_REV_A00
Position the middle leg assembly in the center of the Track. Space the other two Leg Assemblies evenly
either side of the middle leg so that they are spaced 682 mm apart - outside to outside as shown below.
Loosely tighten the bolts securing the Legs to the Track.
()
B