Installation Manual

© 2020 FRONT RUNNER VEHICLE OUTFITTERS
6 FAJK007 / FAJK008_REV_A02
4
FIT AND SECURE
3
13mm
3.4
3.5
3.6
From the inside of the vehicle, in the
same position as where you just
inserted the bolt in 3.4, push the Middle
Support Bracket (Item 2LH & 2RH)
through the hole in the roll bar padding
and loosely fasten it to the roll bar.
Please note that there is a left hand and
right hand bracket. The arrow on the
bracket must point to the rear of the
vehicle.
Pull back the padding around the roll bar
above the rear seats and insert an M8 x
75 Hex Bolt and M8 Large Washer (Items
14 & 15 from FAJK007 box) through the
hole as shown.
13mm
Refit and fasten the Rear Support Arms
as in 2.3
NOTE: Use the worm slots to adjust the
height of the rear support brackets.
This will be important to create a
weatherproof Seal.
10mm
10mm