Installation Manual

4
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
KRHK001T_REV_A00
FIT AND SECURE
2
2.4
Loosley fit one Inner Grip and one Outer Grip
to each Grab On Foot using a M6 Cap Screw,
M6 Spring Washer and M6 Washer.
Inner Grip
Outer Grip
5mm
FIT AND SECURE
3
2.2
2.4
2.1
3.1
3.2
4MM
Make sure that the wind deflector is
installed before you proceed to the next
step.
3.3
Center the rack and tighten fully. Finish off by placing M8 Nut Caps over the M8 Nyloc Nuts.
13mm
Place your Tray on the vehicle positioning all
the feet so that they rest over the roof rails.
Position the rack so that the LH and RH rear
Grab On Feet measure 40mm from the rear
rail cap as shown. Fully tighten all the M6x50
Cap Screws to secure the Tray onto the rails.
Refit the Front Cover Plates.
3mm
5mm
Tightening Torque 6Nm
Make sure there are no movement on
the rack after fully tightening all the
fasteners.
40mm