Installation Manual

© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3 KRHK001T_REV_A00
FIT AND SECURE
2
2.1
2.2
2.3
Flip the Tray so that the bottom of the Tray
faces up.
Insert four M8x16 Hex Bolts into the
machined slots of the slats as shown.
Insert four M8x30 Hex Bolts into the Slats
machined slots as shown.
Loosely assemble the two Grab on Foot Sets
(Item 3) onto the slats indicated in 2.1 as
shown using M8 Flat Washers and M8 Nyloc
Nuts.
Note one set of Spacers are to be used on the
rear feet as shown.
Refer to GOFR001 fitment guide.
Remove the Front Covers from all the Base
Feet by loosening the two M5x10 Button Head
Screws.
Loosen and Remove the M6x60 Cap Screw,
M6 Spring Washers and M6x20x2 Flat
Washers.
B
A
A
B
3
2
3
1
13mm
3mm
5mm