Installation Manual

© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3 FAIK001_REV_A00
FIT AND SECURE
2
2.1
2.2
2.3
Starting at the front windscreen as
shown, measure along the Ditch
Moulding towards the rear of the
vehicle. Mark the Ditch Moulding at the
following distances 240mm and 375mm.
Still measuring from the front wind-
screen mark the Ditch Moulding at the
following distances 1245 mm and 1410
mm.
Using a pair of tin snips, cut the Ditch
Moulding on each of your marks and
remove the small strips of Ditch
Moulding between markings 1-2 and
3-4.
Looking at the ditch, where you have
just removed the Ditch Moulding, locate
the two Thread
ed Mounting Points in
the vehicle's roof and remove the
Protective Tape covering them.
Windscreen