Installation Manual

4
Install track...
(
g
)
Before drilling the holes in the roof, you need to do a bit of prep. Take both the 4 & 7mm drill bits.
Using some insulation tape, wrap a band of tape around the drill bit to act as a stopper to prevent you
from drilling to deep as there are airbags located below where you will be drilling.
10mm from tip of drill bit to start of tape.
Drill the 8 holes you marked earlier, starting with a 4mm pilot hole before going to the larger 7mm hole.
(
h
)
Silicone around each
hole and place a
aluminium spacer on
top of the silicone.
(
i
)
The Aluminium Tracks ship with the Rubber Lining loosely fitted in place. There are two quick steps to prep
the Rubber Lining and the Tracks. First, remove the paper to expose the glue. Then carefully centre the holes
in the Rubber Lining with the holes in the track and press the Rubber Lining into place.
Using a utility knife trim the rubber at the end of each track.
Place the Tracks on top of the Aluminium Spacers lining up the holes. Bolt the Tracks to the roof using the
M6 x 35 Countersunk Bolts and M6 Spring Nuts. Unwind the spring to give you a "handle" to aid lining up
the nut with the bolt and stop the nut from turning. Tighten using a 4mm Hex key.
Refit the roof lining to the vehicle.
(
j
)
congratulations: you have completed the installation!