Installation Manual

3
Install track
Drop/remove the roof head liner.
You will need to use a T20 & T30
Spline bit to loosen the Bolts.
()
A
()
B
Looking at the roof on the outside of the vehicle, you
will see the weather strip. Using a tape measure and a
marking pen, measure 75mm from the front
windscreen and mark the rubber as indicated.
(
C
)
Peel the weather strip from the vehicles body towards
the front, stopping when you reach your measured
mark from Step 2B. Using a pair of side cutters, cut
the strip along the mark. Remove the weather strip
exposing the gutter.
From the rear of the vehicle
follow the weather strip until
you find a joint line. Using a
utility knife, cut the weather
strip along the joint line.
()
d
()
e
Place the Track over the exposed gutter 65mm from
the front windscreen. There is a left and a right track.
The bend in the Track should be to the front and
facing the outside of the vehicle.
(
f
)
Mark position of the holes in
the Track onto the vehicles roof
with a marking pen. There will
be four holes per track.
75MM