Installation Manual

4
3
2
1
© COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
3 TRAC003_REV_A00_MV
2.1
Remove the vehicles' interior head lining and factory fitted roof rails if fitted. Determine best possible
position for mounting the tracks. Positioning over the ditch molding is preferred and take care not to
drill into or through any reinforcements. Mesure and trim the tracks to the desired length.
FIT AND SECURE
2
10mm
2.6
Fit and secure the tracks with the
supplied fasteners. (Items 1, 4 and 5)
Reinstall vehicles interior head lining
removed in step 2.1
10mm
2.2
Once you are happy with the placement of the track, mark all the holes using a suitable marking pen.
2.3
Drill a 4mm pilot hole and then open up the pilot hole with a 7mm drill bit. Take care when drilling.
2.4
Peel off the double sided tape backing from the tracks (Item 2) and apply the protective rubber trim
(Item 3). Remove the excess with a craft knife.
2.5
Apply a bead of suitable sealant to each hole drilled in step 2.3
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
5
Now's the time to visit your favorite Front Runner Dealer in person or Online.
COMPLETION
4
Congratulations. You did it. Take a step back and admire your work!
4mm