Installation Manual

© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3 FADR004_REV_A00
FIT AND SECURE
2
2.1
2.2
2.3
Using a flat screw driver and starting from
the front of the vehicle, lift and remove the
two ditch moldings running along either side
of the roof.
Remove all the retaining clips using a long
nose plier as shown.
Lay the left-hand ditch moulding on an
even surface. From the front tip of the ditch
moulding, measure and mark as shown.
Using a hacksaw, cut the ditch moulding at
each marking.
Discard the three smaller pieces and refit
the retaining clips to the four cut ditch
mouldings making sure the retaining clips
line up with the clip pins in the ditch.
Repeat this for the right-hand moulding.
100mm
180mm
715mm
735mm
1165mm
1265mm
FRONT
Discard
Discard
Discard