Installation Manual
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3
FADR001_REV_A00
FIT AND SECURE
2
2.1
2.2
2.3
Using a flat screw driver and starting from
the front of the vehicle, lift and remove the
two ditch moldings running along either side
of the roof.
Remove all the retaining clips using a long
nose plier as shown.
Lay the righthand ditch moulding on an
even surface. From the front tip of the ditch
moulding, measure and mark as shown.
Using a hacksaw, cut the ditch moulding at
each marking.
Discard the two smaller pieces and refit
the retaining clips to the three cut ditch
mouldings making sure the retaining clips
line up with the clip pins in the ditch.
Repeat this for the lefthand moulding.
355mm
510mm
1115mm
1275mm
FRONT
Discard
Discard