Installation Manual

FASSUNI_REV_A05
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE
2
2.1
2.2
2.3
Place your Front Runner Roof Rack over
your vehicle and find the best position. The
Rack should sit level to the ground, not the
vehicles roof line, or slanting slightly down
toward the front.
Find the best position for the Feet,
using the Combined Slat or Second Slat
(Combined Slat recommended).
Remove the Rack and find a suitable surface
to do the assembly.
Flip the Rack so that the bottom of the
Rack faces up. Insert two M8 x 16 Hex Bolts
(Item 4) into the Slats machined slots that
you have identified.
While your Rack is flipped make sure that
the wind deflector is installed on the first
slat.
Slide the M8 x 20 T-Bolts (Item 3) into the
track as shown, assemble the Foot Base
(Item 2) using M8 x 20 T-Bolts and M8 Nyloc
Nuts (Items 3 & 7).
Wind Deflector
13mm
Fully tighten and then loosen slightly to
allow the foot base to slide in the track.