Installation Manual

RRSTUNI

_REV_A05

RACK ASSEMBLY - WIND DEFLECTOR

Insert two Button Head Bolts, M8 Half Nuts

and Schnorr Washers (Items 2, 4 & 5)

assemblies into the Combined Slat

as shown. Slide them to the center of the

Combined Slat making sure that the

Schnorr Washer is above the T-slot Channel.

Ensure that your Slimline II Tray is upside

down. Check by looking at the product

sticker. It should be upside down as shown.

6.2

6.3

Assemble Items 2, 4 & 5 to both LH & RH

Wind Deﬂectors (Item 3) as shown.

9MM

NOTE : The Wind Deﬂector must be ﬁtted to the underside of the front Combined Slat.

If you are going to put a Leg or Foot on the Combined Slat (Recommended), you will need to slide the M8 Bolt

used for attaching these into the Machined Slots before assembling the Wind Deﬂector.

6.1