Installation Manual

ManualsBrandsFront Runner Manuals4WD & CampingNissan Navara D23 Double Cab (2014-Current) RSI Canopy Slimline II Rack Kit

RRSTUNI

_REV_A05

Joiner Hole

T-slot Channel

U-Channel

RACK ASSEMBLY - SIDE PROFILES

The Side Proﬁles are supplied in pairs.

Take one proﬁle from each pair, one short

and one long (Except for the 2772mm long

Slimline II rack where the Side Proﬁles will

be equal length. Even though both pairs

are the same length it is still important that

you take one Side Proﬁle from each pair).

If you look at the Side Proﬁles you will see

that at one end there is a hole that goes

through the top and bottom of the

"U" Channel.

(Refer to Image 2.1). These are the

Joiner Holes that you will be using.

4MM

Insert a Thick Joiner (Item 3) into the

"U" Channel of the Side Proﬁle lining

up the ﬁrst hole with the hole in the side

proﬁle as show in 2.2.

Now grab a Thin Joiner (Item 4) and

Nyloc Nut (Item 1). Slide the Joiner into the

"T-slot", followed by a Nyloc Nut.

The Nyloc Nut should sit on top of the

Thin Joiner with the "Dome" of the

Nyloc Nut facing up. Line up the outer

hole of the Thin Joiner and Nyloc Nut with

the Joiner Hole and loosely fasten it all

together using a M8 x 45 Button Head Bolt

(Item 2) and a 5mm Allen Wrench.

Slide the matching Side Proﬁle over the two

Joiner pieces, remembering to insert a

Nyloc Nut, and fasten once again using a

M8 x 45 Button Head Bolt. Repeat the above

steps for the other side.

2.1

2.2

If you have received four lengths of Side Proﬁle (Item 5), you will need to join the pieces together using the Joiners

(Items 3 & 4) to form only two lengths by following the easy steps below.

With the exception of the 2772mm long Slimline II Tray, the joints in the Side Proﬁle will be diagonally opposite each other

once the Tray is assembled.

NOTE: Skip this step if your Slimline II Tray is 1560mm or shorter. you will only have two Side Proﬁles and assembly

is not required.

5MM