Installation Manual

4
4
FASSUNI_REV_A03
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE
2
2.2
2.3
2.4
2.1
2.1
2.2
2.3
Before fitting the Feet to the rack, remove
the M8 x 20 T-Bolt (Item 3).
Refer to Figure 1.1.
Loosely fit the Feet to the Rack using
M8 Nyloc Nuts (Item 7) as shown.
The fasteners will be fully tightened after
the rack has been fitted to the vehicle.
7
2
1
While your Rack is flipped make sure that
the wind deflector is installed on the
first slat.
Place your Front Runner Roof Rack onto
your vehicle and find the best position.
The Rack should sit level to the ground, not
the vehicles roof line. Or slanting slightly
down toward the front.
Find the best position for the Feet, using the
first or second Slat.
Flip the Rack so that the bottom of the
Rack faces up. Insert two M8 x 16 Hex Bolts
(Item 4) into the Slats machined slots that
you have identified.
Wind Deflector