Installation Manual

JCHO017_REV_A00
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Loosen the fixings that hold the gutter clamp
to the Jerry Can Holder so that it can be
adjustable when placed on the vehicle.
If needed adjust the Latch (Item 12) using
two M4 x 10 Button head, two M4 Flat
Washers and two M4 Nyloc Nuts (Items 9,11
& 11 ) so that it accomodates your Jerry Can
before fully tightening.
Place the Vertical Jerry Can Holder (Item 8)
on the side of the vehicle so that it fits over
the top gutter and lines up with the two
rivets (Item A) on the vehicle body as shown
in 2.3.
Mark the location of the two holes with a
marker on the bottom mounting holes.
Using a 9mm drill bit, drill holes into the
vehicle. Crimp the M6 Rivnuts (Item 13) into
the holes drilled.
13mm
2.5mm
7mm
9mm
11
12
10
9
A A