Installation Manual

14
13
5
12
12
JCHO013_REV_A00
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE 2
2.4
2.5
2.6
7mm
2.5MM
Decide where on the Rack you want to
mount the Jerry Can Holder.
Slide two M8 Half Nuts (Item 12) into each
of the choosen slat. Secure the Jerry Can
Holder Base (Item 5) to the Rack using M8 x
12 Button Head Bolts and M8 Schnorr
Washers (Items 14 & 13) as shown.
Insert the two Top Straps into the rear slot
in the Jerry Can Holder Base.
Lift the Straps and place the jerry cans into
the Holder.
Open the latches and hook them into the
Latch Keepers on the Jerry Can Holder Base.
Engage the latches.
If the Top Straps are tight and prevent the
latches from fully engaging or if the jerry
cans is still loose see 2.6 for instructions.
Do not set the latches to tight.
If the Latches are to tight and can not engage
fully, move them one hole down and repeat
2.5 to test.
If the Latches are to loose and the jerry can
still move in the Base, move them one hole
up and repeat 2.5 to test.
When you are happy that the jerry cans are
properly secured on the base use an 2.5mm
allen key and a 7mm spanner to fully tighten
the four bolts holding the Latches to the Top
Strap.
5MM