Installation Manual

GBHO013_REV_A00
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.4
2.5
2.6
Assemble the Latch and Catch Brackets
(Item 4 & 5) to the Hinges (Item 3) using M6
x 12 Button Head Bolts, M6 x 12 x 1 SS Flat
Washers, M6 Nylon Washers and M6 Nyloc
Nuts (Items 7, 8, 9 & 10) as shown.
The M6 Nylon Washers (Item 9) go between
the Brackets and the Hinge.
Hang the Gas/Propane Bottle Holder on the
right rear of the vehicle and align vertically.
Mark the mounting hole location. Remove
the Holder and drill a 3mm pilot hole into the
vehicle. Open your pilot hole up will a 8.5mm
drill.
Hang the Holder back and using M6 x 60
Cap Screw, M6 SS Spring Washers and M6
x 19 x 1SS Flat Washers (Items 11, 12 & 13)
to clamp the holder onto the gutter.
Use the M8 x 30 Hex Bolt, M8 x 25 x 2 Flat
Washer and M8 Nyloc Nut (Items 14, 15 &
16) to secure the Holder at bottom as shown.
Place an M8 Nut Cap (Item 17) on the bolt
head to finish of.
Hook the latch into the catch and engage to
clamp the bottle in plate.
See that there is no movement of the bottle
after you have latched it in place.
3
9
6
7
8
6
5
4
8
10
13
12
11
14
16
17
15