Installation Manual

3
REV_A02
()
B
Remove the Fridge Slide and drill a 7 mm hole through the wood on each of your markings. Loosen and
remove the wooden decks. If you have a Drawer System with two layers of wood, it is only necessary to
remove the top layer. Turn the Decks upside down and screw a Wood Insert into each of the 7 mm holes
drilled in Step 1A.
MOUNTING TO a Drawer System or Wooden Deck
Place your Fridge Slide on top of the wooden deck / Drawer System in the desired location. Open the
Fridge Slide and mark the position of the six mounting points as indicated by the arrows onto the deck.
()
A
()
C
Secure the Decks back onto the Drawer System. Place the Fridge Slide back into position and secure
using M6 x 20 Hex Bolts, M6 Spring Washers and M6 x 19 Flat Washers supplied.
If the Fridge Slide overhangs the front of the Drawer System or Wooden Deck you will need to use the
supplied Support Plate between the Fridge Slide and Drawer System or Wooden Deck as shown below.