Installation Manual

ManualsBrandsFront Runner ManualsPortable Fridge AccessoriesCargo Slide / Fridge Slide / 80L to 90L

52L 80l FRIDGE SLIDE

FSLI006

INSTALL TIME: 30 mins

REV_A02

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR

VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY IN-

JURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER

PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PROD-

UCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTION

AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDER-

STAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOR-

OUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSION

AL INSTALLER OR OTHER QUALIFIED PERSONNEL.

Summary of content (5 pages)

PAGE 1
52L - 80l FRIDGE SLIDE FSLI006 INSTALL TIME: 30 mins IMPORTANT WARNING! IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO OTHERS.
PAGE 2
GET ORGANIZED... You will need: 4 mm Hex Key Secure Strapping Plates The front and rear Strapping Plates are shipped loosely fastenend. Lift / pull the Plates up until they hard stop and secure in position by tightening the M6 Button Head Bolts as shown. Below is a list of Tools and Components you will require for each of the recommend methods of fitting your Fridge Slide. Take a moment to familiarize yourself with these Fitting Instructions all the components received.
PAGE 3
MOUNTING TO a Drawer System or Wooden Deck (A) Place your Fridge Slide on top of the wooden deck / Drawer System in the desired location. Open the Fridge Slide and mark the position of the six mounting points as indicated by the arrows onto the deck. (B) Remove the Fridge Slide and drill a 7 mm hole through the wood on each of your markings. Loosen and remove the wooden decks. If you have a Drawer System with two layers of wood, it is only necessary to remove the top layer.
PAGE 4
MOUNTING TO a Drawer System or Wooden Deck (c) Congratulations, you have completed your installation. Take a step back and admire your work. Good Job! MOUNTING TO LOAD BAY using rivnuts (A) Place your Fridge Slide in the desired location. Open the Fridge Slide and mark the position of the six mounting points as indicated by the arrows onto the load bay. Remove the Fridge Slider. (B) Drill a 9 mm hole on each of the markings. Insert and crimp a M6 Rivnut into each hole.
PAGE 5
MOUNTING TO LOAD BAY using nuts & bolts (A) Place your Fridge Slide in the desired location. Open the Fridge Slide and mark the position of the six mounting points as indicated by the arrows onto the load bay. Remove the Fridge Slider. (B) Drill a 6.5 mm hole on each of the markings. Place the Fridge Slide back in position and secure using the M6 x 30 Hex Bolts, M6 Spring Washers and M6 Flat Washers and M6 Nyloc Nuts supplied.