Installation Manual

3
REV_A01
()
B
Remove the Fridge Slide and drill a 7 mm hole through the wood on each of your markings. Loosen and
remove the wooden decks. If you have a Draw System with two layers of wood, it is only necessary to
remove the top layer. Turn the Decks upside down and screw a Wood Insert into each of the 7 mm holes
drilled in Step 1A.
(
C
)
Secure the Decks back onto the Draw System. Place the Fridge Slide back into position and secure using
M6 x 20 Hex Bolts, M6 Spring Washers and M6 x 19 Flat Washers supplied.
MOUNTING TO a Draw System or Wooden Deck
Place your Fridge Slide on top of the wooden deck / Draw System in the desired location. Open the Fridge
Slide and mark the position of the six mounting points as indicated by the arrows onto the deck.
()
A
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
()
D