Installation Manual

5
/
Toyota Hilux fortuner
LATE 2012 onwards
BBTH001
Remove the Speaker Cover covering the Speaker and mount the Speaker to the ECU Mounting Bracket as
shown.
45mm
Remove the Speaker Mounting Bracket and Cut the Switch off 45mm from the end as shown.
Wet/paint the tip of the Stud protruding from the vehicle's
body with a white marker. Press the Switch and Bracket
up into position against the Rubber Seal and Stud as
shown, marking the position of the Stud onto the back of
the Bracket. Drill a 6.5mm hole in the Bracket on your
mark.
Secure the Switch upon final fitment (Refer to Step 3B) as
shown.
REV_A00