Installation Manual

3
PREPARE FOR INSTALL
On the left hand side of the engine bay, locate and remove the securing bolt as indicated.
()
A
From inside the left wheel arch insert one of the M6 x25 Hex Bolts and one M6 x19
Flat Washer (Items 5 & 10) through the bolt hole in the vehicles body from Step 2A.
()
B
Remove
()
C
Loosely fit the Battery Bracket (Item 12) in place and mark the position of the hole on the foot of the stand
to the vehicle's body. Remove the Battery Bracket and drill a 6,5mm hole on your mark. Treat the hole
with Anti-rust paint/coating.
Mark Hole
Position onto
Vehicle.
Drill 6.5mm Hole on
Mark
()
D
Loosely assemble the Support Bracket Parts 1 &2 (Items 3 &4)
as shown using the M6 x16 Countersunk Bolt, M10 Flat Washer,
M6 x19 Flat Washer and M6 Nyloc Nut (Items 1, 2, 5, 6).
M10 Flat Washer
REV_A01