User's Manual

Standby Mode (Power Saving)
The Wii U Pro Controller will automatically enter standby mode for power saving when it
hasn’t been used for a period of time or it has been disconnected. Press any button on the Wii
U Pro Controller top face for recall.
Troubleshooting
The Wii U Pro Controller does not work
(1). If the Wii U Pro Controller fails to operate, or operates incorrectly, follow the steps below before
seeking assistance.
Make sure the Wii U console and the Wii U Pro Controller are both turned on.
Make sure the Wii U Pro Controller is within the operating distance.
Make sure the battery of the Wii U Pro Controller is charged.
Make sure the Wii U Pro Controller has been synchronized with the Wii U console.
Make sure the Wii U Pro Controller is connected to the Wii U console.
(2). If after verifying the steps above, the Wii U Pro Controller does not work or work not correctly, try
the following:
Turn off the power of the Wii U console.
Wait for a few seconds, and then turn on the power of the Wii U console.
a. Press the RESET button in the back hole of
Wii U Pro Controller to reset the controller.
b. Wait for a few seconds and then resynchronize the Wii U Pro Controller and the Wii U console.
Wii U is a trademark of Nintendo, Inc., registered in the U.S. and other countries.
All other trademarks are the property of their respective owners.
FCC STATEMENTS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC ID: TAZWL053
MADE IN CHINA
Warning:
Modifications not approved by the party responsible for compliance could void user’s
authority to operate the equipment.