Card

EN-US

Starting for the

First Time via

Web Browser

To start Fronius Datamanager 2.0 for the first time,

- the Fronius Datamanager 2.0 plug-in card must be installed in the inverter,

- there must be a Fronius Datamanager Box 2.0 in the Fronius Solar Net ring.

IMPORTANT! To establish a connection to Fronius Datamanager 2.0, the end device in

question (e.g., laptop, tablet) must be configured as follows:

- "Obtain an IP address automatically (DHCP)" must be activated

Connect the inverters with Fronius Datamanager 2.0 or Fronius Datamanager Box 2.0

in Fronius Solar Net

IMPORTANT! Inverters Fronius IG, Fronius IG Plus, Fronius IG Plus V, Fronius IG

Plus A, Fronius CL, Fronius CL USA, and Fronius IG 300–500 must always be located

at the beginning or end of the Fronius Solar Net ring.

For Fronius Galvo/Fronius Symo/Fronius Primo only and when linking multiple invert-

ers in Fronius Solar Net:

Set the Fronius Solar Net master/slave switch on the Fronius Datamanager 2.0 plug-

in card as required

- One inverter with Fronius Datamanager 2.0 = master

- All other inverters with Fronius Datamanager 2.0 = slave (the LEDs on the Fro-

nius Datamanager 2.0 plug-in cards are off)

NOTE! The Fronius Solar.web App makes starting Fronius Datamanager 2.0 for

the first time significantly easier.

The Fronius Solar.web App is available in the relevant app store.

WARNING! An electric shock can be fatal. Danger from grid voltage and DC volt-

age from solar modules.

Before opening the inverter:

- You must wait until the capacitors have discharged.

- Follow the operating instructions when opening the inverter.

- Observe the safety rules and safety instructions contained in the inverter's

operating instructions.