Instruction Manual

8
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread Tape
or Sealant
Two hose adapters
1½” X 1½” X 1¼”
Two Sections of 1½”
or 1¼” Flex Hose (one
provided with  lter)
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under
chlorination, replace eyeball
 ttings in the return jets to a
smaller or larger size to adjust
back pressure. For best results
use King Technology’s pressure
gauge, order Part No.
01-22-4000.
Apply pipe thread tape or sealant
to the threaded end of both hose
adapters.
1.
Sand Filter Installation with Flex Hose Only
Screw adapters into each end of FROG
Pool Tender Cycler. Hand tighten. Finish
tightening by turning 1 to 2 revolutions with
pipe wrench. DO NOT OVER TIGHTEN.
2.
Attach the  lter section of  ex hose to one hose adapter
and the return section of  ex hose to the other hose
adapter with clamps and tighten with screwdriver. Bi-
 ow valve design allows water  ow installation in either
direction.
3.
To prevent damage to heaters
or  lters, install a corrosion
resistant check valve which will
reduce the back  ow of chlorine
gas when the system is turned
off.
4.
For better stability, FROG Pool Tender Cycler
may be mounted on a treated wood base using
Phillips pan head screws, one in front and two in
back. If you have questions about stability, please
contact your dealer or King Technology.
5.
The FROG Pool Tender Cycler should
always be installed between the  lter
and pool (or between heater and pool
if applicable). Never install FROG Pool
Tender Cycler before the heater or
damage to the heater could occur.