Instructions / Assembly

Assembly Instructions
Sport Bench 4 FT
Components
Tools for Assembly: Powered driver and 7/16 Socket
Tape Measure
(2) Bases
(1) Bench Slat
(10) Hex Lag Screws &
Flat Washers
Step by Step Assembly
Before you begin: Check components to verify all are included. Assembly will require two people and must be performed on a level
and smooth surface. Do not overtighten hardware as damage can occur.
Step 1
Set the two bench bases in the upright position and parallel to
each other approximately 2 1/2 feet apart.
Step 2
Lay the two bullnose bench slats across the bases with one towards
the front and the other to the back, the remaining bench slat will lie
evenly spaced between the bullnose slats. Align the mounting holes
in the slats with the pre-drilled holes in the bases. Attach using the
hex head screws and flat washers, do not over-tighten.
As of 01/2020
Cleaning Tips
Frog Furnishings products are durable and designed to last a lifetime, like most things that spend the majority of time outdoors,
sometimes they need a little cleaning. In most cases, all a Frog product requires is mild dish soap, a bucket of warm water and a clean
cloth. Apply the soapy mixture to scrub away the dirt and then rinse with water. If you have some stubborn dirt down in the grooves
and divots, mix 1 part bleach to 2 parts water, apply with your clean cloth, scrub with a soft bristle brush if needed and then rinse.
(2) Bullnose Bench Slat