Owner's manual

GTM-System page 15
3.2.2 Ending Measuring
• Select from the menu Measurement the command Close or
press the button close recording (arrow).
• Switch off the mill
• Leave the grinding bowls in the mill to cool off.
• Switch off transmitter unit
- plug-in switch plug or charging cable in transmitter unit or
recharge accumulators on receiver:
plug-in charge cable on transmitter unit and receiver.
• Take the grinding bowls out of the mill when cooled off
• Clean grinding bowl, balls and filter cover if necessary.
See chapter
6 Cleaning
• At the end of measuring save data:
Menu File option
Æ save
Æ save as
3.3 Saving / loading of measurements
After completion of the measuring process, data may be saved by use of
save file (File / Save) or save file as (File / Save as).
You may also save the measuring values in ASCII-format for use in Ex-
cel, etc.
At a later point in time you may display again the measuring values by
use of open file (File / Open).