Owner manual

8 Cleaning
DANGER!
Mains voltage!
– Before beginning with cleaning work, disconnect the
mains plug and protect the device against being unin-
tentionally switched back on!
–
Do not allow any liquids to flow into the device.
– Indicate cleaning work with warning signs.
– Put safety equipment back into operation after
cleaning work.
When cleaning the entire device, adhere to the guidelines of
the Accident Prevention Regulation (BGV A3) ‐ especially
when the device has been set up in a dusty environment or
when the grinding stock processed produces dust.
8.1 Grinding elements
n Clean the grinding bowl and grinding balls each time after using
them: Clean them, e.g., under running water using a brush and a
commercially available cleaning agent.
n Half fill the grinding bowl with grinding balls, sand and water, and
run for 2 to 3 minutes (correctly tensioned) in the planetary mono
mill.
n Cleaning with an ultrasonic cleaner is permitted.
n For sterilisation in the heat cabinet, only heat the grinding elements
up to 100 °C.
8.2 Mill
n The planetary mono mill can be wiped down with a damp cloth
when it is switched off.
Cleaning
- 50 -