User Manual

5 Initial start-up

Perform initial start-up only after all work as described in

Chapter 4

‘Installation’ on page 18 has been carried out.

5.1 Switching on

n Connect the device to the grid

n Switch the device on at the main switch (I ON)

5.2 Function check

n Open the hood.

n Take out any grinding bowl clamping devices and wood - the

grinding bowl holder must be completely empty - and close the

hood.

n Hold down the Program button until "1" appears on the LED display.

(In the delivery condition only memory location 1 has been allocated

a low motor speed).

n Press START button.

n The hood is locked and the mill runs at the programmed speed.

5.3 Switching off

n Press the STOP button.

n After a short time, once the mill is at standstill, the hood is unlocked

and can be opened.

Initial start-up

- 23 -