User guide

page 3
PULVERISETTE 25
Table of contents
page
1 General Information / Introduction............................................................................................ 5
1.1 Basic Design..........................................................................................................................................5
1.2 Notes about Operating Instructions.......................................................................................................7
1.3 Explanations of the signs at the instrument and in the operating instructions ......................................8
1.4 Brief Description of the Instrument ........................................................................................................9
1.4.1 Applications................................................................................................................................................9
1.4.2 Method of Operation...................................................................................................................................9
1.4.3 Drive Motor.................................................................................................................................................9
1.5 Technical Data.....................................................................................................................................10
1.5.1 Dimensions ..............................................................................................................................................10
1.5.2 Weight......................................................................................................................................................10
1.5.3 Noise level................................................................................................................................................10
1.5.4 Nominal voltage / Power consumption / Power output / Current input or required supply-side fusing......10
1.5.5 Electric fuses............................................................................................................................................10
1.5.6 Material ....................................................................................................................................................10
1.5.7 Throughput...............................................................................................................................................10
1.5.8 Final fineness ...........................................................................................................................................10
1.5.9 Speed.......................................................................................................................................................10
2 Operating Safety....................................................................................................................... 11
2.1 General Safety Instructions .................................................................................................................11
2.2 Operators.............................................................................................................................................11
2.3 Protective Equipment...........................................................................................................................12
2.3.1 Opening the cover flap, when the machine is not connected to the mains supply ...................................12
2.4 Danger Points......................................................................................................................................13
2.5 Electrical Safety...................................................................................................................................14
2.5.1 General ....................................................................................................................................................14
2.5.2 Protection against Restarting ...................................................................................................................14
2.5.3 Direction of Rotation Detection.................................................................................................................14
2.5.4 Overload Protection .................................................................................................................................14
3 Installation................................................................................................................................. 15
3.1 Unpacking............................................................................................................................................15
3.2 Transport .............................................................................................................................................15
3.3 Erection................................................................................................................................................15
3.4 Fastening the Cutting Mill ....................................................................................................................15
3.5 Ambience conditions............................................................................................................................16
3.6 Electrical Connection...........................................................................................................................16
3.7 Before Switching On for the First Time................................................................................................16
3.8 Switching On for the First Time / Test for Correct Functioning ..........................................................17
3.8.1 Switching On............................................................................................................................................17
3.8.2 Switching Off............................................................................................................................................17