Manual

1.
Open the cutting mill (see
Ä Chapter 6.1.1 ‘Opening the cutting
mill’ on page 28).
2. Pull the rotor (3) forwards, wearing safety gloves. If the rotor (3)
jams somewhat, lever it out carefully.
3. Clean the cone-shaped rotor holders (3).
4. Clean both cone-shaped holders (cones) in the closing lid (6) and
on the holder.
5. Push the rotor (3) onto the rotor holder. Turn it clockwise until it
engages in the 4 driving pins (C) on the back. (The control switch
(19) must be at AUTO)
Using the device
- 32 -