User Manual

6.14 Control panel
When the mill is switched on, the values of the last milling are displayed.
n Timer: Range "P", "1"-"99" min, where "P" means continuous opera-
tion.
n Speed: Range "6"-"20" (x1000 rpm), adjustable in steps of 1000, i.e.
a speed between 6000 and 20000 rpm can be selected.
n Load lights up when the motor is overloaded by too much source
material.
n Temperature: Off when operation is fault-free.
Flashes at elevated temperatures. The current milling process
can still be carried out, but the sample feed rate should be
decreased. Afterwards, restarting is only possible after cooling
down.
Continuously lit up at excessive temperatures; the motor is
switched off. Restarting is only possible after cooling down.
Remains lit when the mill is switched on and when the tempera-
ture sensor is not in proper working order or is still too hot.
Using the device
- 40 -