Owner's manual

6.1 Control panel
n When the grinding chamber is open, the button (h) for locking the
grinding chamber is not lit.
n The button (h) flashes green as the grinding chamber closes by
motor, and continues flashing until it is closed. Then it stays lit
green.
n During the start-up, the Start button (e) flashes green. Once the
device is running, it stays lit green.
n When the device is stopped, the Stop button (f) flashes until the
wheel has come to a standstill. At standstill, it is lit red.
n If a dust extraction system is attached, the button (g) lights up green
when it is activated.
n The +/- keys (a,b) are used for setting values and for changing
menus.
n The arrow keys (c,d) are intended for selecting the menu items and
for selecting the menu switch bar.
6.2 Menu navigation
1. The menu parameter serves for:
‒ Setting the gap width between the grinding disks® Gap
‒ Setting the grinding time in minutes® Time
2. In the Check/Setup menu you can:
‒ Define the "zero point"® No gap between the
Grinding disks
‒ Change the direction of rotation of the movable grinding disk
(6)® Revers
‒ Set the language® Language
Menu selection
Using the device
- 24 -