Manual

5 Initial start-up
The disk mill is delivered with mounted grinding disks. Check the gap
width before the first grinding. (See
Ä Chapter 6.2 ‘Setting the gap
width’ on page 23). After the disk mill has been set up as described in
Ä Chapter 4 ‘Installation’ on page 17 and the mains plug has been
plugged into the mains socket, the device is ready for operation.
CAUTION!
– Grinding disks must not touch each other.
–
The device may be operated only when the grinding
disks have been mounted and fixated.
– Smallest gap width 0.1 mm
5.1 Switching on
Switch main switch (10) to ON (I). The disk mill starts up.
5.2
Switching off
Switch main switch (10) to OFF (O). The disk mill stops within a few sec-
onds.
Initial start-up
- 20 -