User Manual

6.2.4 Converting the crushing plates (17, 21) and support walls (11)
The conversion is carried out as described in
Ä Chapter 5.2 ‘Replacing
the crushing plates (17, 21) and support walls (11)’ on page 26
6.2.5 Converting the grinding opening blocks (10)
i Hex wrench - size 5
k Plastic mallet
1. The blocks (10) are each attached to the lid (1) with one cylinder-
head screw and 2 dowel pins.
2. To replace the blocks (10), undo the cylinder-head screws using a
hex wrench (i). Unscrew the screws by about 5 to 10mm. Do not
remove the screws completely; otherwise, the blocks will fall into
the grinding chamber.
Tools
Conversion
Accessories
- 41 -