User Manual

c Hex wrench - size 6

f Socket wrench - size 13

g Hex wrench - size 4

h Open-ended wrench - size 13

i Hex wrench - size 5

n Cross-head screwdriver

1. First, lift the fixed crushing jaw (13) as described in

Chapter 5.2.1 ‘Replacing the crushing plate (17) of the fixed

crushing jaw (13)’ on page 26 out of the Jaw Crusher.

2. Then, remove the 6 fastening screws of the belt guard (6) using a

cross-head screwdriver (n) and lift off the belt guard (6). The fly-

wheel (22) can be seen.

3. The support wall is attached to the left-hand side wall with 5 hex-

agon screws. These only need to be loosened and not removed

completely.

Tool

Replacing the left-hand support wall

Working with the laboratory jaw crusher

- 33 -