User guide

Page 2
Table of contents page
1 Basic Design.........................................................................................4
2 Safety Instructions and Proper Use....................................................6
2.1 Requirements on the Operator .....................................................................6
2.2 Proper use.....................................................................................................6
2.2.1 Method of Operation............................................................................................6
2.3 Obligations of the Operator...........................................................................7
2.4 Warnings Used .............................................................................................7
2.5 Machine safety instructions...........................................................................8
2.6 Safety equipment.......................................................................................... 9
2.7 Hazard points................................................................................................ 9
2.8 Electrical safety............................................................................................. 9
2.8.1 General................................................................................................................9
2.8.2 Protection against warm restart ...........................................................................9
3 Technical Data ....................................................................................10
3.1 Dimensions .................................................................................................10
3.2 Weight.........................................................................................................10
3.3 Working noise ............................................................................................. 10
3.4 Voltage, Current consumption, Power consumption................................... 10
3.5 Electric fuses...............................................................................................10
3.6 Material ....................................................................................................... 10
3.7 Final fineness.............................................................................................. 10
4 Installation...........................................................................................11
4.1 Transportation............................................................................................. 11
4.2 Unpacking ...................................................................................................11
4.3 Setting up....................................................................................................11
4.4 Ambient requirements................................................................................. 12
4.5 Assembling the funnel (1) ...........................................................................12
4.6 Electrical connection................................................................................... 14
4.6.1 Matching the jaw crusher to the mains voltage..................................................14
4.6.2 Drive motor ........................................................................................................14
4.6.3 Direction of rotation of drive motor.....................................................................14
4.7 Initial switch-on / performance check..........................................................15
5 Working with the jaw crusher............................................................15
5.1 Selection of crushing plates and lateral support walls ................................15
5.2 Mounting the crushing plates (18, 22) and lateral support walls (13) ......... 16
5.2.1 Mounting the crushing plates.............................................................................17
5.2.2 Checking the gap...............................................................................................18
5.2.3 Mounting the support walls ................................................................................19
5.3 Crushing of material....................................................................................20
5.3.1 Setting the jaw gap ............................................................................................20
5.3.2 Introducing the material to be crushed...............................................................20
5.3.3 Dust exhaust......................................................................................................20
5.3.4 Final size............................................................................................................21
5.3.5 Setting of the link plate ......................................................................................21