Installation Guide

CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person
move or lift the dryer.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person
move or lift the dryer.
1 When washer is within 4 feet of its fi nal installation
site, electrical and water connections have been
completed, and washer is level, have two or more
people lift the dryer onto the washer.
4 Slide the dryer approximately
¼” to the left to
disengage dryer from rear brackets.
5 Support the front of the dryer, clearing the front
bracket, while sliding the dryer forward. Have two or
more people lift the dryer off the washer and gently
place it on the fl oor.
2 Holding the front of the dryer up slightly, carefully
slide the dryer back.
3 Slide hook tabs on rear brackets into slots in
backsheet of dryer. Dryer will be approximately ¼”
left of center. Continue sliding dryer back until tabs
are fully engaged.
4 Slide dryer approximately ¼” to the right, centering
it on washer and hooking rear bracket tabs into slots
on back.
5 Lift front of dryer and remove RED backing from
adhesive strip on front bracket.
6 Gently lower dryer to adhere front bracket to washer
top. Align dryer side panel to washer side panel as
you lower dryer.
C) Stacking dryer D) Connecting dryer
Removing stacked dryer
IMPORTANT
Refer now to dryer INSTALLATION INSTRUCTIONS
including connections and venting.
WARNING
FIRE HAZARD
Improper installation of dryer venting could result in
personal injury or damage to property.
NOTE
If laundry appliances must be moved, front and rear
mounting brackets may remain attached to the washer
top until the dryer is restacked. To permanently unstack
the units and remove the front bracket, use a 24” piece of
monofi lament (fi shing) line to carefully saw back and forth
under the adhesive strip. Remove residue with a general
adhesive remover.
1 Disconnect dryer from electrical and gas connections
and exhaust venting. On models with Steam Option,
disconnect water supply to dryer.
2 Disconnect washer from electrical source.
3 With #2 square bit screw driver, remove two front
bracket screws and save for reinstallation.