Installation Guide

CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person
move or lift the dryer.
IMPORTANT
DO NOT REMOVE RED BACKING FROM ADHESIVE
STRIP YET!
IMPORTANT
If this is a new installation, washer should now be
moved to within 4 feet of its fi nal location. Refer to
INSTALLATION INSTRUCTIONS, including connections
and leveling, before continuing.
IMPORTANT
DO NOT REMOVE ANY EXISTING SCREWS FROM
FRONT PANEL!
1 If already installed, disconnect dryer from electrical
and gas connections and exhaust venting. On
models with Steam Option, disconnect water supply
to dryer.
2 Protect fl oor with cardboard or other covering and
carefully tip dryer onto its back.
Prepare top surface of washer
1 Wipe front
portion of top
with isopropyl
alcohol and a
clean cloth.
3 Remove adjustable leveling legs and save for future
use.
4 Attach front stacking bracket to dryer front with 2
#10 screws.
5 Carefully return dryer to upright position.
2 Carefully remove BLUE backing from clear self-
adhesive strips. Apply to each side edge of the
washer top.
3 Attach each rear bracket (according to washer style
below) to washer top with 2 #10 screws.
A) Preparing dryer for stacking B) Preparing washer for stacking
ENGLISH
REMOVE
For washers with 3 indents
on side in shape of “III”
and depth of top panel is
24.0" (61 cm), use short
rear brackets.
For washers with 3 indents
on side in shape of “I0I”
and depth of top panel is
26.4” (67 cm), use long
rear brackets.
24.0"
(61 cm)
26.4"
(67 cm)