User manual

ManualsBrandsFrigidaire ManualsDomestic AppliancesPLHV36W8CC

Charcoal filter

 The charcoal filter should only be used if you want to use

the hood in the recirculation function.

 To do this you will need an original FRIGIDAIRE

charcoal filter (available from your local Service Force

Centre).

 Cleaning/replacing the charcoal filter

Unlike other charcoal filters, the LONGLIFE charcoal

filter can be cleaned and reactivated. At normal use the

filter should be cleaned every second month (when using

the hood 2,5 hours per day, in avarage). The best way to

clean the filter is in the dishwasher. Use normal detergent

and choose the highest temperature (65º C). Wash the

filter separately so that no food parts gets stuck on the

filter and later causes bad odours. To reactivate the

charcoal, the filter should be dried in an oven for 10

minutes with a temperature of maximum 100º C.

After approximately three years of use, the carbon filter

should be replaced with a new, as the odour reduction

capacity will be reduced.

 Fitting

Remove the frame i which supports the filter h by turning

90° the two knobs g.

Insert the charcoal filter inside the frame and put all parts

back in their place. Fig. 5.

 To remove proceed in the reverse order.

 Always specify the hood model code number and serial

number when ordering replacement filters. This

information is shown on the registration plate located on

the inside of the unit.

 The charcoal filter can be ordered from your local

FRIGIDAIRE Service Force Centre.

Changing the light bulb - Fig. 6

 Disconnect the cooker hood from the main supply.

 Press (1) the lamp cover (2) and open it.

 Replace the old bulb with a new one of the same type (3).

 Close the lamp cover (4).

 If the light does not come on, make sure the bulb has

been inserted correctly before contacting your local

Service Force Centre.

Technical assistance service

You are welcome to telephone our technical assistance

service (see list of technical assistance centres) whenever

you need information or in the unlikely event of a fault.

For service in Australia call 1300 650 020.

When calling, please be ready to specify:

1. The model code number

2. The serial number (E-Nr.)

3. The manufacturing number (F-Nr.)

This information is shown on the registration plate

inside the unit behind the grease filter.

We reserve the right to change specifications and colours

as a result of our policy of continuing technological

development.

Fig. 5

Fig. 6