Owners Guide

43
CARE AND CLEANING
burner
cap
burner
head
igniter
orifice
CAUTION
Be sure the range is unplugged and all parts are
COOL before replacing oven light. Wear a leath-
er-faced glove for protection against possible
broken glass or burns.
Replacing the oven lights
The oven light bulbs are located at the rear of the
oven cavity and both are covered with a glass
shield. The glass shield must be in place whenever
the oven is in use.
Replacing the interior light bulbs:
1. Turn electrical power o at the main source or
unplug the range.
2. Remove carefully oven interior light shield as
illustrated below.
3. Replace bulb with a new T-4 type 25 Watt
Halogen appliance bulb. Please note: Do not
allow your fingers to touch the new bulb when
replacing. This will shorten the life of the new
bulb. Use a paper towel to cover the new bulb
when installing.
4. Replace glass shield over bulb.
5. Turn power back on again at the main source
(or plug the range back in).
6. The clock will then need to be reset.
Figure 18: Storage drawer open Carefully remove
glass shield
4. Wipe the burner cap and head clean with a
soft, clean cloth, sponge, or scratch free
cleaning pad.
5. Before using the cooktop again, make sure the
burner caps and heads are properly placed and
seated properly over the igniter. When placed
correctly, the burner cap is centered on the
burner head and will click into place on the
burner head. You can wiggle the cap to test
placement, it should not move o the burner
head.
Removing the Storage Drawer
Use the storage drawer for storing cooking utensils.
The drawer can be removed to facilitate cleaning
under the range. Use care when handling the
drawer.
Figure 19: Storage drawer closed
Figure 20: Carefully remove glass shield