Owners Manual

9
To Cancel a Cycle and Delay
Cycle
Both a running cycle and a delay cycle can
be canceled at any time.
Open the dishwasher door and press the
START/Cancel button until the cycle and
option LEDs turn o. The running cycle or
delay countdown is canceled.
Press the START/Cancel button and close
the door immediately to drain. After a 90
second drain you may be able to select a
new cycle after canceling a previous wash
cycle.
Opening the door during cycle
If you open the door while a cycle is
running or delay is counting down, the
dishwasher will stop running.
The LEDs of selected cycle and options
are illuminated, the status window displays
the remaining cycle time. The LED above
START/Cancel button will blink to press
start.
To resume, press START/Cancel
button and close the dishwasher door
immediately.
The status window displays “CLOSE door”
after the START/Cancel button is pressed.
If the dishwasher door is kept open for
too long, or the door is closed without
pressing START/Cancel button, the
running cycle or delay countdown will be
canceled.
OPERATING INSTRUCTIONS
Status Indicator Lights
Status Window
The STATUS window, available on some
models, indicates the following activity:
In the unlikely event that the dishwasher
malfunctions, displays the error code
“Uo”, or gives poor performance you can
call the Frigidaire Customer Care Center
at 1-800-944-9044. They will be able to
provide assistance in troubleshooting the
problem and/or locating an authorized
service technician, if needed.
If it is desired to have the console lights
remain o while running, perform the
following operation: Prior to starting
a cycle, press and hold Heavy Wash
and Rinse Only simultaneously for
approximately 8 seconds until the
corresponding lights flash. This will
turn the console lights o during cycle
operation. Simply repeat this operation
to revert back to the previous setting.
Console Lights
The console lights provide information
about the cycle selection and current
status. During operation, while the door
is closed, these lights will remain on. At
the completion of the cycle, the clean
light will come on. The Sanitized light will
also come on if that option was selected
and sanitization was achieved during the
wash cycle.
Green Light
The GREEN LIGHT illuminates on the floor
when the wash is complete.
Blue Light
The BLUE LIGHT illuminates on the floor to
indicate that the wash cycle is operating.
1H-24H............. Number of delay start
hours. The last hour
will count down in
minutes.
MINUTES.......... Number of minutes
left in cycle (1-199).
CLOSE DOOR.... Close door will
scroll one time in the
status window.