Owners Manual

7
CONTROLS AND SETTINGS
Option Selections
2
START/Cancel Button
When cycle and options are
selected, LEDs of selected cycle and
options are illuminated. The status
window displays the cycle time.
To start the cycle, press the START/
Cancel button and immediately
close the dishwasher door.
You can cancel a cycle anytime
during the cycle. Press and hold the
START/Cancel pad for 3 seconds.
The light above the cycle and option
selected will go out, and the START/
Cancel light will remain illuminated,
the dishwasher will start a 90 second
drain. At the end of the drain, select
the next desired cycle.
3
Status Window
The Status Window indicates the
number of delay start hours, the
number of minutes left in a cycle,
and the CLOSE message.
The cycle time will be extended
until the proper water temperature
is reached. Washing action will
continue during the water heating
delay. For best results, the incoming
water temperature should be at least
120° F (49° C).
The sanitize criteria may not be
satisfied if there is an interruption
of the cycle, power failure or if the
incoming water temperature is
below 120° F (49° C).
To turn o the Sanitize option,
press Wash Temp until the desired
temperature option is selected. The
indicator light will turn o.
High Wash Temp Option
When High Wash Temp option
is selected, the dishwasher
heats water in the main wash to
approximately 140° F (60° C).
This increase in water temperature
helps the dishwasher detergent
remove food grease and soil from
dishes more eectively and aids in
drying. High Wash Temp option is
available on Heavy Wash, Normal
Wash and Top Rack cycles. High
Wash Temp is automatically
provided when the Heavy Wash
cycle is selected.
When High Wash Temp option is
selected, the indicator light will
come on and remain on until end
of cycle. To turn o the High Wash
Temp option, press Wash Temp until
the desired temperature option is
selected. The indicator light will
turn o.
6
Dry Options
The programmed cycles default to
the Heat temperature option, to
choose MaxBoost, Heat or Air, press
the Dry pad.
MaxBoost Dry
TM
When MaxBoost Dry
TM
option is
selected, the dishwasher extends
drying time by approximately 20
minutes. The MaxBoost Dry
TM
option can be used with all cycles
except China Crystal, Energy
Saver and Rinse Only. For best
drying performance, also apply an
increased wash temperature by
selecting High Wash Temp or even
better, the Sanitize option.
4
Wash Pressure
The programmed cycles default to
the “surge” pressure option which
varies the pressure optimally for
the cycle’s intended normal use.
If, for some special circumstance,
either a very low “spray” or very
high “scour” pressure is desired that
may be selected. Due to wash cycle
optimization, some pressure options
are not selectable in all wash cycles.
5
Wash Temp
The programmed cycles default to
the “normal” temperature option,
to choose High or Sanitized press
Wash Temp pad.
Sanitize Option
To sanitize your dishes and
glassware, select the Sanitize
option. When selected, the indicator
light will come on and remain on
until the end of cycle. The water
temperature in the final rinse will be
raised to 156° F (69° C). This option
is available in Heavy Wash, Normal
Wash and Top Rack Cycles. Only
these sanitization cycles have been
designed to meet NSF requirements.