Installation Guide

30” ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS

C. Level and Position Range - Level range by adjusting

the (4) leveling legs with a wrench. Note: Aminimum

clearance of 1/8” (3 mm) is required between the

bottom of the range and the leveling leg to allow

room for the bracket. Use a spirit level to check your

adjustments. Slide range back into position. Visually

check that rear leveling leg is inserted into and fully

secured by the Anti-Tip Bracket by removing lower

panel or storage drawer.

4. Electrical Connection

Requirements

Avoid re hazard or electrical shock.

Failure to follow this warning may casue serious injury,

re, or death.

This appliance must be properly installed and grounded

by a qualied technician in accordance with the National

Electrical Code ANSI/NFPA No. 70 or Canadian Electrical

Code (CSA Standard (C22.1 Part 1) latest editions, and

Local Electrical Code requirements.

For personal safety, this appliance must be properly

grounded. For maximum safety, the power cord must be

plugged into an electrical outlet that is correct voltage, is

correctly polarized and properly grounded in accordance

with local codes.

It is the personal responsibilty of the consumer to have the

appropiate outlet with the correct, properly grounded wall

receptacle installed by a qualied electrician.

Fig. 7

5. Models Including Power

Cord (Canada)

Plug the 4-prong range power cable into a properly

grounded, 240V wall outlet.

240V grounded

wall receptacle

Power supply

cord with 4-prong

grounding plug

Range Side or

Cabinet Side

(0”, 0.5 mm)

Fig. 8