User manual
Check to see that the refrigerator’s
plug is not connected on top of the
power cord.
Connect the refrigerator to its own
outlet. Do not use an extension cord
or adaptor plug.
For your safety, ask an electrician to
verify the condition of the electric
wiring in the area where the
refrigerator will be installed.
The wires leading to the outlet into
which the refrigerator will be plugged
should be made of copper and be at
least 2.5 mm2 wide. For greater
safety, consult the legislation on
electrical installations in your country.
Note: Turning the temperature
control to OFF turns off the
compressor.
Grounding
The power cord has a three-pronged
grounded plug for your personal
safety. It must be connected to a
grounding type wall receptacle, in
accordance with the legislation
governing electric installations in
your country, as well as any local
regulations. Do not remove the
grounding prong, do not use a two
pronged adaptor, and never make a
connection to the schematic. Use
the cord supplied with the equipment
(do not change it). If the cord is
damaged, it must be immediately
replaced by specialized personnel.
How to turn on the refrigerator
01. Clean the parts of the refrigerator
with warm water containing a little
neutral detergent and with clear
water,and wipe them dry.
02. Turn the thermostat knob to the
"MAX" position, turn on electricity.
The compressor inside the
refrigerator begin to work.
03.iiOpen the door 30 minutes later, if
the temperature in the refrigerator
decreased obviously, it shows
that the refrigerator system works
well. When the refrigerator
operates for a period of time, the
temperature controller will
automatically set the temperature
within limits it opens.
Electric parts of the refrigerator can
only be wiped by dry cloth.
Filling the refrigerator
Follow these instructions the first time
you fill the refrigerator, or after you
defrost it.
01. Turn the refrigerator on and let it
run for two hours prior to putting
food inside.
02.xIf the food is fresh, put it in the
refrigerator little by little, in one
hour intervals.
03.iAfter filling the refrigerator, adjust
the thermostat to the appropriate
position, following the instructions
under item "Temperature
Adjustment".
Usage instructions
For your safety, installation must be
grounded. If it is not grounded, it must be
adapted for this by specialized personnel.
Attention
ENG
ENG
33
34