Trim Kit Installation Instructions

INSTRUCTION SHEET
©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21
17
Leveling the Unit
4. a. Tilt the unit upright.
b. Place the unit into the
cabinet space, or as
close to the final position
as possible (do not hook
up power or water yet).
This step is important to
accurately level the unit
prior to further installs.
c. Use a flat head screw
Fig. 8

NOTE
Some cabinet substrates may require pre-drilling holes using a
1
/
8
”
(3 mm) diameter drill bit.
driver or a
3
/
8
” socket wrench to adjust the front bolts of
the Leveler Assemblies (Fig. 8). Raise or lower the front
and back wheels as needed until the unit rests properly in the
cabinet space.
d. Once the Leveler Assemblies have been checked, roll out
the unit in front of the cabinetry for accessibility.
Electrolux TRMKTSS1LV84 Side Trim Attachment Setup
5. Using eight 3H screws and
a power drill, attach the
2 Side Trim Attachment
brackets to the front left and
right cabinet cutout edges
with the brackets touching
the floor (Fig. 9). Ensure the
rectangular slots extend over
the cabinet edge.
Fig. 8
Frigidaire TRMKTEZ1FL79 Side Trim Attachment Setup
6. Depending on which long
screw you received (6H or
7H) screw a long screw in
the lower left area (Fig. 9A)
of the front cabinet space,
approximately in the location
described in Fig. 9B.
7. Repeat step 6 for the right
side of the cabinet using the
other 6H/7H screw.
Power and Water Line Connection
Note: Refer to the Use & Care Manual for power requirements and water
supply hookup before proceeding. Find Service Kit TTFLTRICEKIT at
ElectroluxAppliances.com for connecting the water line and filtering ice.
Top Trim Attachment

NOTE
You will need a step ladder to install top trim components.
8. a. Remove the front outer
screw from the top hinge
(Fig. 10) using a
5
/
16
”
socket driver or wrench
and save for later. Locate
bracket 1H and place it
on the top of the unit to
be used on Step 8d.
b. Roll the unit into the
cabinet roughly  of the
way in, ensuring the
product is centered in the
cabinet cutout.
c. Choose the top trim
according to which side
the door hinge is on
(Fig. 11). You do not need
the other Top Trim for
the installation.
d. Install the Top Trim by
fastening two 4H screws
along the base of the
trim with a
5
/
16
” socket
wrench (Fig. 12). Screw
through the 1H bracket in
step 8a to properly level
the Top Trim.
1H
Fig. 10
Fig. 11
Fig. 12
9. a. Slide the unit into place,
and ensure the dual
installation is centered.
b. Drill
1
/
8
” pilot holes and
fasten two 3H screws
on the right side of the
Top Trim with a Phillips
screwdriver to cabinets
(Fig. 13).
c. Repeat for the left side.
Fig. 13
Fig. 9
A
B
Fig. 20
0.50 inches