Trim Kit Installation Instructions

INSTRUCTION SHEET
©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21
13
Pairing Kit Installation
Before cleaning your appliance, turn off power to your appliance by
unplugging the power cord from the electrical outlet. Wipe down both
sides of the refrigerator and the freezer.

NOTE
Never use CHLORIDE to clean stainless steel. Clean stainless-steel front
and handles with non-abrasive soapy water and a dishcloth. Rinse with
clean water and a soft cloth. Wipe stubborn spots with an ammonia-
soaked paper towel, and rinse. Use a non-abrasive stainless-steel
cleaner, such as Frigidaire ReadyClean™ Stainless Steel Cleaner
found on Frigidaire.com. Always follow the manufacturer’s instruction.

NOTE
Always, clean, wipe and dry with the grain to prevent scratching.
Wash the rest of the cabinet with warm water and mild liquid
detergent. Rinse well and wipe dry with a clean soft cloth.
. Peel off the paper backing from the first heater.
7. Adhere the first heater to the lower right side of the left-side unit (0.5"
from the bottom and 0.5" from the back wall) so the harnesses come
out at the top.
Fig. 9
0.5"
0.5"
0.5"
A
B
NOTE Make sure you adhere
the heater completely with no
air pockets (Fig. 9A).
8. Peel off the paper backing
from the second heater.
9. Adhere the second heater to
the upper left side of the right-
side unit (0.5” from the top
and 0.5” from the back wall)
so the harnesses come out at
the bottom.
NOTE Make sure you adhere
the heater completely with no
air pockets (Fig. 9B). For better
adhesion remove the yellow label
on the side of the cabinet.
10. Plug in the connector of the
two Heaters A into the Power
Supply C (Fig. 10).
NOTE: You cannot feel the heater
temperature as the pads barely
heat up.
C
Fig. 10
A
B
NOTE: Confirm the power supply
fits into the cutout when placed
on top of the unit. Also confirm the
power supply reaches the power
outlet when placed on top of the
unit (Fig. 11A). The extra wire length
is provided to accommodate
receptacle location.
11. Apply the 2 strips of double-
sided tape to the power
supply and adhere the power
supply on top of the unit
(Fig. 11B).
Fig. 11
A
B
NOTE For the best results, please
use the configurations of the
heaters mentioned (Freezer- top
right side and Refrigerator bottom
left side).
Avoid:
• Both heaters on the Freezer
• Both heaters on the Refrigerator
• Both heaters on the top
• Both heaters on the bottom
• Both heaters in the center
12. If the power supply cannot
be placed on top of the unit,
adhere it vertically on the
back wall of the unit and
make sure the connection of
the 3-prong connector to the
power supply is facing down
(Fig. 12).
Fig. 12
CAUTION
Use gloves for the next step.
NOTE: Before removing the paper backing, align the heaters to ensure
the wires exit toward the center and rear of refrigerator/freezer (as shown
in Fig 9).