Trim Kit Installation Instructions

INSTRUCTION SHEET
©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21
12
Fig. 3
Fig. 5
3. a. Fit the first Leveler
Assembly onto
a refrigerator/freezer
(Fig. 3).
Fig. 4
b. Using a 5H bolt and
a power drill, fasten the
bottom of the Leveler
Assembly with a
3
/
8
”
hex drill bit in whichever
hole overlaps the screw
hole (Fig. 4).
Note: The rear of the
bracket is contoured to
slip over the metal
compressor base. Driving
the rear bolt first will
ensure proper alignment
of the lever assembly.
c. Using the 4H bolts from
step 1, fasten the front of
the Leveler Assembly
to the refrigerator/freezer
using a
5
/
16
” nut driver
(Fig. 5).
Fig. 6
Fig. 7
For steps 3b and 3c, if
you require more space
for nut driver clearance,
rotate the bolt labeled
F clockwise (Fig. 6) using
a flathead screwdriver or
a
3
/
8
” socket wrench.
d. Attach remaining 3
Leveler Assemblies as
described in the previous
3 steps using the
remaining six 4H bolts
and the remaining three
5H bolts.
With the unit(s) still on
their backs, adjust all
leveling wheels to
approximately the
orientation in Fig. 7.
Trim Kit Center Trim Support
4. With the refrigerator still on its
back, use a
5
/
16
” nut driver to
remove two 4H bolts and fasten
the 10H L-Bar (Fig. 8).
Note: The short flange on L-Bar
should be facing upward toward
the top of the refrigerator.
Fig. 8
5. Stand both units upright.
CAUTION
The cabinet is heavy. We recommend two people to lift or move the cabinet..