Use and Care Guide

Operating Instructions
8
2019 Electrolux Home Products, Inc. All rights reserved.
Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut down and
the BUCKET FULL indicator will illuminate.
b. Do not move the unit at this time otherwise water
may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from
the unit.
d. Remove the bucket as shown in the photographs
below and empty the bucket.
e. Replace the empty bucket back into the unit and once
seated correctly, the unit will start up again.
f. You should hear a click when the bucket is in the
correct position.
3. If the display reads "P2", Bucket is full or removed or not
in right position. Replace the bucket in the right position.
Fault Codes
1. If the display reads "AS" or "ES" , a sensor has
failed. Contact your Authorized Frigidaire Service
Center.