Use and Care Guide

Operating Instructions

(continued)

1. Before entering TIMER setting, make sure power is being supplied to the unit.

2. Before entering TIMER setting, make sure pressing HUMIDITY or button sets one desired room humidity first.

NOTE:

Operating Instructions

5. After a few days when the Relative Humidity has declined,

press the Cont. Drain button to deactivate the Cont. Drain

feature then press the HUMIDITY or buttons to

choose a value between 35% to 85%, so the room is kept

at a comfortable humidity. Pressing the or buttons

will change the humidity selection in 5% increments. After

you have set the desired humidity, the readout will

display the actual room humidity.

6. When the unit is on, first press the Timer button, the Timer

Off indicator light illuminates. It indicates the Auto Stop

program is initiated. Press it again the Time On indecator

light illuminates. It indicates the Auto Start is initiated.

When the unit is off, first press the Timer button, the TIMER

ON indicator light illuminates. It indicates the Auto Start

program is initiated. Press it again the Time Off indecator

light illuminates. It indicates the Auto Stop is initiated.

Press or hold the UP or DOWN pad to change the Auto time

by 0.5 hour increments, up to 10 hours, then at 1 hour

increments up to 24 hours. The control will count down the

time remaining until start.

The selected time will register in 5 seconds and the system

will automatically revert back to display the previous

humidity setting.

When the Auto start & Auto stop times are set, within the

same program sequence, TIMER ON OFF indicator lights

illuminate identifying both ON and OFF times are now

programmed.

Turning the unit ON or OFF at any time or adjusting the

timer setting to 0.0 will cancel the Auto Start/Stop function.

When LED display window displays the code of P2, the Auto

Start/Stop function will also be cancelled.